ข้ามไปยังเนื้อหาหลัก
กลับไปโปรไฟล์ผู้เชี่ยวชาญ

ผศ.ดร.วิรัช ทวีปรีดา

ผลงานตีพิมพ์ทั้งหมด

76 public publications

Page size102550

Deproteinization of Natural Rubber Latex and Its Pale-Colored Thin Films

Jirapornchai Suksaeree, Chanin Bumroongrat, Nantanat Polraksa, Wirach Taweepreda, Thawatchai Phaechamud, Wiwat Pichayakorn

Sustainability · 2023

The non-rubber components present in natural rubber latex can contribute to the dark color of dried films and may cause allergic reactions. This project aimed to develop light-color rubber films with minimal protein contamination. Various additives were incorporated, and a leaching procedure was implemented to address this issue. The evaluation focused on protein content, color changes, and swelling properties of thin natural rubber films. Texapon N70 proved effective as both a latex stabilizer and leaching agent, while Uniphen P-23 served as a preservative. The combined use of these additives facilitated the removal of soluble serum through appropriate incubation, leaching, and centrifugation processes. The introduction of additional centrifugation cycles improved deproteinization and color reduction; however, it led to a loss of rubber mass and an increase in manufacturing costs. Increasing the amount of Texapon N70 and introducing alkali potassium hydroxide (KOH) further enhanced the efficiency of deproteinization and color reduction. The optimal conditions determined in this investigation were as follows: 0.5% w/w Texapon N70, 0.5% w/w KOH, 1% w/w Uniphen P-23, a 60-min incubation period, and a single leaching cycle with distilled water. These conditions resulted in a 90.57 ± 1.20% decrease in protein contamination and a color change (ΔE) of 433.69 ± 20.23. This successful condition can be replicated and scaled up for further applications.

Exploring the potential of thermophilic anaerobic co-digestion between agro-industrial waste and water hyacinth: operational performance, kinetic study and degradation pathway

Audrey Chai, Yee‐Shian Wong, Soon‐An Ong, Nabilah Aminah Lutpi, Sam Sung Ting, Wirach Taweepreda, Wei-Chin Kee, H.H. Khoo

Bioprocess and Biosystems Engineering · 2023

Impact of Climate Change on Cassava Yield in Nigeria: An Autoregressive Distributed Lag Bound Approach

Casmir Ndukaku Anyaegbu, Kingsley Ezechukwu Okpara, Wirach Taweepreda, David Akeju, Kuaanan Techato, Robert Ugochukwu Onyeneke, S. Poshyachinda, Siwatt Pongpiachan

Agriculture · 2022

Across the globe, climate change is threatening the environment, crop yield and food security. The key to ensuring a sustainable environment, crop yield increase and food security is to identify the long-term significant impact of climate change and the means of reducing the effect. This study examined the impacts of climate change on cassava yield in Nigeria. Data were sourced from the Climate Change Knowledge Portal and the Food and Agricultural Organization of the United Nations spanning from 1990 to 2019. The impact of climate change was analyzed using Autoregressive Distributed Lag Bound approach, Error Correction Model and Augmented Dickey–Fuller and Phillips–Perron tests for stationarity test. The model was subjected to diagnostic tests such as stability tests, normality tests, serial correlation tests and heteroscedasticity tests. With the exception of temperature, the study revealed that arable land, rainfall and greenhouse gases such as C2O, nitrous oxide and methane had a long-term significant impact on cassava yield in Nigeria. The study also noted that methane causes long-term significant damage to cassava yield more than any other greenhouse gas and climatic variables in the study. We recommended policies and programs that facilitate the uptake of climate-smart agriculture that centers on greenhouse gas emission reduction and on crop improvement research by breeding crop varieties that will be resilient to climate shocks.

Advanced extraction and separation approaches for the recovery of dietary flavonoids from plant biomass: A review

S. A. Gokula Krishnan, G. Arthanareeswaran, Gnanaselvam Gnanasekaran, Zsuzsanna László, Gábor Veréb, Szabolcs Kertész, Wirach Taweepreda

Biomass Conversion and Biorefinery · 2022

Investigation of intrinsic bisphenol separation capacity of zeolitic imidazolate framework-8 based membranes

Sujithra Sundarajan, Yohannan Subin Sabilon, G. Arthanareeswaran, Wirach Taweepreda

Desalination and Water Treatment · 2021

ABSTRACT The present study deals with the synthesis of polyetherimide (PEI)-based membrane with zeolitic imidazolate framework (ZIF) nanoparticles as fillers by wet phase technique. The synthesized membranes were characterized based on their physical and chemical properties and were used to study the effective removal of Bisphenol A (BPA) from water. After the BPA removal with different membrane compositions, it was found that 1% PEI/ZIF-8 mixed matrix membrane gave maximum BPA rejection of 94.1% in comparison with other membranes. The flux recovery ratio of 0.92 was also found to be the highest for 1% PEI/ZIF-8 membrane which shows that this membrane has undergone the least fouling when compared to other membrane compositions. Overall, a 1% concentration of PEI/ZIF-8 membrane showed better characteristics and a maximum percentage of BPA removal was obtained.

Improvement of the Mechanical Properties by Guar Gum Addition of Epoxidized Natural Rubber/Polyethylene Glycol Composite Membranes

Kritsada Phatcharasit, Wirach Taweepreda

Lecture notes in mechanical engineering · 2021

Propranolol Hydrochloride Film Coated Tablets Using Natural Rubber Latex Blends as Film Former

Wiwat Pichayakorn, Kamon Panrat, Jirapornchai Suksaeree, Wirach Taweepreda

Journal of Polymers and the Environment · 2021

Energy conversion from wastewater sewage sludge

Arif Billah, Kuaanan Techato, Wirach Taweepreda

Asia-Pacific Journal of Chemical Engineering · 2020

Abstract Natural rubber‐based industries in Southern Thailand are generating concentrated latex sewage sludge (CLS), which is commonly managed by landfilling practice that is causing serious environmental hazards. The purpose of this study was to develop a method to produce pellets using CLS and para‐wood sawdust as a potential biomass source for energy generation. The process started with dewatering the CLS through a decanter centrifuge. Then a flat die pellet mill was applied for copelletization. Finally, the pellets were investigated to evaluate the higher heating value and toxic heavy metals (Cu, Zn, Cr, As, Cd, and Pb) using proximate ‐ ultimate analysis, fourier transform infrared analysis, scanning electron microscopy, calorific value, thermogravimetric analysis, atomic absorption spectrometer, and inductively coupled plasma optical emission spectroscopy. The results showed that the addition of the para‐wood sawdust resulted in higher heating value and lower ash content of 3,620 ± 12 kcal/kg and 4.93 ± 0.98%, respectively. Besides, it has increased the carbon content of the pellet from 28.23 to 46.26% highest among all the samples. Furthermore, the method developed in this study is not only environmentally friendly but also economically sound than the earlier management of CLS.

Preparation and characterization of polymer electrolyte membrane from chloroacetate chitosan/chitosan blended with epoxidized natural rubber

Qamber Ali, Wirach Taweepreda, Kuaanan Techato

Polymer Testing · 2019

The effect of field natural rubber latex pretreatment with cationic exchange resin on latex dipped film properties

S. Kaewthai, Sineenart Puangmanee, Wirach Taweepreda

Journal of Rubber Research · 2019

Page 4 of 8

การใช้คุกกี้วิเคราะห์

เว็บไซต์นี้ใช้ Google Analytics เพื่อดูภาพรวมการใช้งาน เช่น จำนวนผู้เข้าชมและหน้าที่ได้รับความสนใจ โดยจะเปิดใช้เมื่อคุณยอมรับเท่านั้น

ยังไม่ได้เลือก