ข้ามไปยังเนื้อหาหลัก
กลับไปโปรไฟล์ผู้เชี่ยวชาญ

รศ.ดร.กุลภา โสรัตน์

ผลงานตีพิมพ์ทั้งหมด

36 public publications

Page size102550

A Life Cycle Assessment Based Evaluation of a Coupled Wastewater Treatment and Biofuel Production Paradigm

Monica Christine Rothermel, Amy E. Landis, William J. Barr, Kullapa Soratana, Kayla M. Reddington, Matthew K. Weschler, Grace Witter, Willie F. Harper

Journal of Environmental Protection · 2013

A laboratory experiment was performed to determine the feasibility of coupling a conventional wastewater treatment system with an algal photobioreactor (PBR) for the removal of nutrients from wastewater and production of renewable resources. An activated sludge batch reactor was set up in series with an algal PBR to feed synthetic wastewater to Chlorella vulgaris. The nutrient concentration in the water as well as lipid content, carbohydrate content, and growth rate of the algal biomass were tested over 10 cycles to determine the capabilities of the coupled system. The study revealed complete nutrient removal in some cycles, with the average final nutrient content of 2 mg-P/L and 3 mg-N/L in effluent of the PBR. The algae biomass contained 24% ± 3% lipids and 26% ± 7% carbohydrates by dry weight. A life cycle assessment revealed the highest energy demand occurred during harvesting of the algal mixture through centrifugation or filtration, but the highest global warming and eutrophication impacts were due to CO2 use and PBR construction material production. It is feasible for the system to treat wastewater while generating renewable resources, but the system must be optimized to reduce life cycle environmental impacts and result in a net energy gain before large-scale implementation is possible.

Life Cycle Assessment of Microalgal Biodiesel and Policy Implications to Minimize Unintended Consequences

Kullapa Soratana

D-Scholarship@Pitt (University of Pittsburgh) · 2012

The overall goals of this research are to identify forms of environmentally friendly microalgal biodiesel production and to address the broader policy implications of the Renewable Fuel Standard 2 (RFS2) to avoid unintended environmental consequences from the production and the utilization of biofuels. Life cycle assessment (LCA) of microalgal biodiesel was conducted using a process LCA model with Monte Carlo Analysis (MCA) for uncertainty analysis. First, the study focused on environmental impacts from the production of microalgal mass. Twenty scenarios of microalgal cultivation with different sources of CO2, nutrients and material used to construct photobioreactor (PBR) were evaluated. The results showed that the utilization of CO2 from flue gas only reduces global warming potential (GWP), while the utilization of nutrients from municipal wastewater mainly reduces eutrophication potential (EP), and the selection of material used to construct PBR is important. LCA of microalgal biodiesel was conducted to evaluate the major contributions to different environmental impacts and to identify the production condition with minimal impacts. Environmental impacts from four different microalgal biodiesel production scenarios to achieve the biomass-based diesel quantity required by the RFS2 were quantified. These four scenarios included lower and higher production efficiencies and different sources of resources, which are synthetic, and natural and waste. None of the four scenarios met the RFS’s greenhouse gas emissions requirement. The emissions can be minimized by improving the energy efficiency of harvesting process, since the GWP results are sensitive to energy consumption in harvesting process. Sensitivity of EP, ozone depletion potential and ecotoxicity potential to other parameters are also reported. GWP, EP and photochemical smog formation potential (PSP) results from the scenario with minimal impacts were compared to the impacts from other diesels, petroleum diesel, soybean diesel and canola diesel. The tradeoffs between different types of diesel suggested that future RFS should include other environmental criteria such as EP and PSP to minimize unintended consequences. Possible strategies to setting life-cycle EP and PSP criteria are discussed. Finally, a LCA on the co-production of microalgal biodiesel and bioethanol from microalgae and corn were conducted. CO2 for microalgal cultivation was provided from flue gas and/or fermentation processes. The recovery of CO2 from fermentation process decreases GWP, but slightly increases EP. The co-production of the microalgal biofuels can reduce GWP and EP by 54 and 52%, respectively, compared to the production of microalgal biodiesel alone. Lipid and carbohydrate contents of microalgae should be 24-36% and 44%, respectively, in order to produce the maximum energy content in algal biofuels with the minimum GWP and EP impacts.

Microalgal biodiesel and the Renewable Fuel Standard's greenhouse gas requirement

Kullapa Soratana, Willie F. Harper, Amy E. Landis

Energy Policy · 2012

Evaluating industrial symbiosis and algae cultivation from a life cycle perspective

Kullapa Soratana, Amy E. Landis

Bioresource Technology · 2011

Increasing innovation in home energy efficiency: Monte Carlo simulation of potential improvements

Kullapa Soratana, Joe Marriott

Energy and Buildings · 2009

Performance characterization of biological wastewater treatment systems using 5-day biodegradable dissolved organic carbon and ultraviolet absorbance at 254 nanometers

Kullapa Soratana, Eakalak Khan, Sutha Khaodhiar

2004

Biodegradable dissolved organic carbon (BDOC) and ultraviolet absorbance at 254 nm (UV254) which have been widely used in the drinking water field were investigated for their applicabilities to be used as wastewater quality parameters and treatment efficiency indicators. Three bench-scale biological wastewater treatment processes, activated sludge (AS), trickling filter (TF) and rotating biological contactor (RBC), were fed with primary wastewater from fullscale municipal wastewater treatment plants. First, relatively low organic concentration primary wastewater was used as an influent for TF and RBC that were operated at three different hydraulic loading rates (HLR). The results indicated that effluent BDOC5 and its removal of TF and RBC were not much different across different HLRs but the trends were reasonable. The UV254 reslts indicated that TF and RBC removed minimal amount of UV absorbing constituents. When applying higher organic concentration primary treated wastewater fromanother treatment plant as an influent tothe three biological wastewater treatment systems, AS system was operated at five different solid retention times (SRT), while TF and RBC were operated at four different HLRs. For AS, higher SRTs slightly increased BDOC5 removal but has no effect on UV254 removal. For TF and RBC, the effluent BDOC5 and their removal results were very similar; the values increased with higher HLRs. The UV254 results showed that TF barely removed UV254 absorbing constituents. The applicabilities of BDOC5 and UV254 were supported by a fairly strong linear relationship between BDOC5 and UV254. BDOC5 can be used as an indicator of secondary wastewater quality and treatment process performance, while UV254 can be used only for characterizing quality of wastewater.

Page 4 of 4

การใช้คุกกี้วิเคราะห์

เว็บไซต์นี้ใช้ Google Analytics เพื่อดูภาพรวมการใช้งาน เช่น จำนวนผู้เข้าชมและหน้าที่ได้รับความสนใจ โดยจะเปิดใช้เมื่อคุณยอมรับเท่านั้น

ยังไม่ได้เลือก